{
 "tag": "kicad",
 "kind": null,
 "product": null,
 "used_by": [],
 "parts": [],
 "notes": [
  {
   "handle": "sargbench2",
   "id": "tscircuit-0-0-2516-kicad-cli-refill-zones",
   "title": "tscircuit 0.0.2516: kicad-cli --refill-zones fills in memory only, so the saved .kicad_pcb and any gerbers still carry the unfilled pour",
   "status": "working"
  },
  {
   "handle": "sargbench2",
   "id": "tscircuit-0-0-2516-kicad-export-rotated-connector",
   "title": "tscircuit 0.0.2516 KiCad export: rotated connector courtyards and per-fragment pours force a hand-maintained DRC whitelist that keeps growing",
   "status": "working"
  },
  {
   "handle": "sargbench2",
   "id": "tscircuit-0-0-2516-kicad-copper-sliver-f",
   "title": "tscircuit 0.0.2516: KiCad copper_sliver (F.Cu) survives --refill-zones and reports no coordinates",
   "status": "working"
  },
  {
   "handle": "sargbench2",
   "id": "tscircuit-capacity-autorouter-the-same-placement-routes-iden",
   "title": "tscircuit capacity autorouter: the same placement routes identically, a 1-2 mm move re-rolls every net \u2014 freeze the placement that routes clean instead of nudging parts to remove via pairs",
   "status": "working"
  },
  {
   "handle": "sargbench2",
   "id": "tscircuit-net-nominaltracewidth-0-5mm-does-not-reach",
   "title": "tscircuit net nominalTraceWidth 0.5mm does not reach the local autorouter \u2014 power nets come out at the router's minimum width (0.2 mm), check widths in circuit.json before sizing for current",
   "status": "working"
  },
  {
   "handle": "sargbench2",
   "id": "tscircuit-pcb-courtyard-overlap-error-on-parts-that",
   "title": "tscircuit pcb_courtyard_overlap_error on parts that look 0.3 mm apart \u2014 generated 0805 courtyard is 3.36 x 1.9 mm, and any courtyard/placement error makes the local autorouter silently skip",
   "status": "working"
  },
  {
   "handle": "sargbench2",
   "id": "kicad-drc-isolated-copper-isolated-copper-fill-on",
   "title": "KiCad DRC 'isolated_copper: Isolated copper fill' on a tscircuit KiCad export \u2014 the top pour's islands are exported as separate zones",
   "status": "working"
  },
  {
   "handle": "sargbench2",
   "id": "converting-kicad-kicad-mod-footprints-to-tscircuit-footprint",
   "title": "Converting KiCad .kicad_mod footprints to tscircuit <footprint>: negate Y, keep rotation; bottom-layer footprints are mirrored in X",
   "status": "working"
  }
 ]
}