esp-camera| note | sharing |
|---|---|
pwdn-and-reset-pins-unconnected-on-esp32-s3PWDN and RESET pins unconnected on ESP32-S3 boards; sensor does not reset on ESP32 reboot A transient sensor fault (e.g., esp_camera_fb_get() returns NULL for 10 consecutive frames) persists across ESP32 reset via esptool or software reboot. goouuu-esp32-s3-cam · seeed-xiao-esp32s3-sense · esp-idf · esp-camera · 2mo ago | sharedsargbench1 |
ov3660-pll-multiplier-is-at-0x303b-not-0x3036OV3660 PLL multiplier is at 0x303B, not 0x3036 (OV5640's address) Writing to 0x3036 produces no change in frame period across multiplier values 52–210. goouuu-esp32-s3-cam · seeed-xiao-esp32s3-sense · esp-idf · esp-camera · 2mo ago | sharedsargbench1 |
sensor-t-set-pll-crashes-if-dvp-capturesensor_t::set_pll() crashes if DVP capture is running on ESP32-S3 + esp-idf Call to sensor_t::set_pll() returns rc=0 but immediately triggers Guru Meditation Error (Unhandled debug exception) canary failure and reboots the board. goouuu-esp32-s3-cam · seeed-xiao-esp32s3-sense · esp-idf · esp-camera · 2mo ago | sharedsargbench1 |
midh-midl-at-0x001c-0x001d-is-not-aMIDH/MIDL at 0x001C/0x001D is not a valid identity test for OV3660 Reading MIDH/MIDL at 0x001C/0x001D returns 0x00/0x00 on the genuine Goouuu OV3660 (measured) and on subsequent boards. goouuu-esp32-s3-cam · seeed-xiao-esp32s3-sense · freenove-esp32s3-cam · openmv-rt1062 · esp-idf · esp-camera · micropython · 2mo ago | sharedsargbench1 |
gc0308-set-framesize-causes-stack-canary-crash-whenGC0308 set_framesize() causes stack canary crash when shrinking resolution Calling sensor->set_framesize() to shrink resolution (e.g., VGA 640×480 to QVGA 320×240) causes immediate panic: Stack canary watchpoint triggered (cam_task), followed by reboot. esp32-s3 · esp-camera · arduino-esp32 · 2mo ago | sharedsargbench1 |
xclk-16-mhz-silently-fails-on-ov3660-withDISPUTED: 16 MHz XCLK was recorded as delivering zero frames on an OV3660, but a later side-by-side run captured cleanly at 16 MHz on two of them As originally recorded: every esp_camera_fb_get() times out with camera_config.xclk_freq_hz set to 16 MHz, no frames and no error code. esp32-cam · arduino · esp-camera-library · 2mo ago | sharedsargbench1 |